C24EO SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS

Handle Installation

1.Apply Lubriplate 630AA around slots of outer door housing where step spacers contact housing.

2.Install door handle into outer door housing such that hinge side of door housing is to the left and arrow on handle is pointed upward.

3.Install step spacer with smaller radius toward handle and door housing. Smaller radius is a slip fit with outer door housing slot.

4.Install lock nuts and tighten until no gap exists between handle, step spacer and lock nut. Do not over-tighten lock nuts.

5.Close inner door panel so that latch mechanism engages striker on front panel.

6.Install outer door housing onto inner door panel.

7.Align the top and bottom screw holes of outer door housing with inner door panel.

8.Apply Loctite 7471 Primer N and Loctite 242 to threads of screws before assembling.

9.Install screws to secure door halves together.

10.Check opening and closing operation of door.

Latch Assembly Removal and Disassembly

1.Separate outer door housing assembly from inner door panel as outlined under DOOR HANDLE REMOVAL.

2.Remove screws securing latch assembly to inner door panel and remove latch mechanism.

3.Remove E-clip from latch assembly pins and pull pins from latch mechanism.

4.Remove retaining pin from spring pin.

5.Separate sliding bracket from stationary bracket.

Page 11 of 24

 

F25386 (June 2010)