Manuals / Vulcan-Hart / Kitchen Appliance / Range

Vulcan-Hart ML-52954, ML-52953 SERVICING SIMPLE CHECKS AND ADJUSTMENTS Cont, Oven Door Turnbuckle

Models: ML-114555 ML-114554 ML-114556 ML-114553 ML-114557 ML-52954 ML-52948 ML-114957 ML-52949 ML-52951 ML-52952 ML-52950 ML-52947 ML-52953

1 52
Download 52 pages 49.32 Kb
Page 8
Image 8
SERVICING SIMPLE CHECKS AND ADJUSTMENTS (Cont.)

SERVICING SIMPLE CHECKS AND ADJUSTMENTS (Cont.)

2. Oven Door Turnbuckle

NOTE: For the 24L and 48L units, refer to procedure outlined under 2A.

If the oven door is not closing properly, the door turnbuckle may require adjustment. To adjust the turnbuckle, flip down the lower front kick panel. The turnbuckle is connected between the right- and left-hand door springs (Fig. 1). With your hand, rotate the cast center piece of the turnbuckle two rotations at a time, then check the door tension. Repeat this procedure until the door works as desired. After adjustment has been made, tighten the locknuts.

Fig. 1

2A. 24L and 48L Oven Door J-Bolt Assembly

If the oven door is not closing properly, the door J-bolt assembly may require adjustment. To adjust the J-bolt assembly, flip down the lower front kick panel. The J-bolt assembly is connected to the right-hand bell crank arm (Fig. 2). The adjustment is made by the two 1/4-20 locknuts. Turn each nut in a clockwise direction to increase tension on the door; turn each nut in a counterclockwise direction to decrease the tension. Repeat this procedure until door works as desired. After adjustment has been made, tighten the locknuts.

Fig. 2

— 8 —

Page 7 Page 9
Page 8
Image 8
Vulcan-Hart ML-52954, ML-52953, ML-52947, ML-52950 SERVICING SIMPLE CHECKS AND ADJUSTMENTS Cont, Oven Door Turnbuckle
Page 7 Page 9