COVERS AND PANELS
Disconnect the electrical power to the machine and follow lockout / tagout procedures.
Control Panel
1.Remove three screws on the right side which secure the control panel. Pull the panel away from the oven.
Top Front Cover
1.The top front cover is secured with four screws, two on each side of cover. Remove these screws, then remove the cover from the oven.
REMOVE SCREWS
TOP FRONT COVER
MASTER SWITCH
MASTER SWITC | H | |
OVEN |
|
|
COOL |
|
|
OFF |
|
|
THERMOSTAT |
| |
POWER LEVEL |
| |
FAN SPEED |
| LIGHTS |
HI | ON | |
LOW | OFF | |
SG4D SHOWN
CONTROL
PANEL
REMOVE SCREWS
OVEN
COOL
OFF
ON
HEAT
IGNITION
2. Reverse the procedure to install.
Bottom Front Cover
1.The bottom front cover is secured with six screws, two on each side of cover and two on the top. Remove these screws then remove the cover from the oven.
REMOVE SCREWS
BOTTOM FRONT COVER
2. Reverse the procedure to install.
2.Disconnect the temperature probe leads from the solid state temperature controller.
3.Unplug the wire harness connector to the control panel components.
4.Reverse the procedure to install.
Right Side Panel
1.Remove the screws that secure the right side of the control panel.
2.Remove the remaining screws securing the right side panel.
3.Pull the
RIGHT SIDE |
REMOVE |
SCREWS |
4. Reverse the procedure to install.
– 7 –
