24.Remove the preattached 3 1/2” Pulleys (78) from the Offset Double
Wrap the Swivel Cable (17) around a 3 1/2” Pulley (78). Attach the Pulley to the Offset Double “U”-
bracket (61) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).
25.Wrap the Swivel Cable (17) around a 3 1/2” Pulley
(78). Attach the Pulley and a Cable Trap (68) to the next to bottom hole in the Small Pulley Plates (31)
with a 3/8” x 2” Bolt (100) and a 3/8” Nylon Locknut (87). Make sure the Cable Trap is turned to hold
the Cable in the groove of the Pulley.
26.Wrap the Swivel Cable (17) around a 3 1/2” Pulley (78). Attach the Pulley and a Cable Trap (68) to the bracket on the Swivel Upright (5) with a 3/8” x 2”
Bolt (100) and a 3/8” Nylon Locknut (87). | Make |
sure the Cable Trap is turned to hold the Cable |
|
in the groove of the Pulley. |
|
27. Attach the end of the Swivel Cable (17) to the
bracket on the Swivel Carriage (46) with a 3/8” x 1” Bolt (13) and a 3/8” Nylon Locknut (87).
28.Locate the Lat Cable (88), which is 89 1/4” long and has a ball on one end and an eyelet on the other. Route the eyelet end of the Cable up through the Butterfly Top Frame (7) and around a 3 1/2” Pulley (78). Attach the Pulley inside of the Butterfly
Top Frame with a 3/8” x 2 3/4” Bolt (101), two 3/8” Washers (91), two 1/2” Spacers (89), and a 3/8”
Nylon Locknut (87).
13
24 |
|
|
|
|
|
| 17 |
|
|
| 78 |
| 87 |
| 93 |
|
|
| |
| 61 |
|
|
25 |
|
|
|
| 31 |
| 100 |
| 87 |
| |
|
|
| |
| 78 |
|
|
| 68 |
|
|
| 17 |
|
|
26 | 100 |
| |
|
| ||
| 5 |
|
|
| 87 |
|
|
| 68 | 78 | 17 |
27 |
|
|
|
| 46 |
|
|
| 87 | 13 |
|
|
|
| |
| 17 |
|
|
28 |
|
|
|
| 78 |
|
|
| 87 |
|
|
| 91 |
|
|
| 89 | 89 |
|
|
| 91 | |
| 7 |
| |
|
| 101 | |
| 88 |
|
|
