Weider 831.153931 user manual Only, Nylon Locknut 120, A 3/8 Nylon Jamnut, 124

49.	Wrap the Swivel Low Cable (72) over a 3 1/2”				49
	Pulley (78). Attach the Pulley and a Cable Trap (68)
	between the lower set of holes in the “U”-bracket
	(64) with a 3/8” x 2” Bolt (100) and a 3/8” Nylon
	Locknut (87).	Make sure that the Cable Trap is				100
	turned to hold the Cable in the groove of the							64
	Pulley.					68
								87
						72
								78
50.	Attach the end of the Swivel Low Cable (72) inside				50
	of the Short Base (2) with a 5/16” x 2 1/2” Bolt (59),
	two 5/16” Washers (90), and a 5/16” Nylon Locknut
	(86).
					86	90
						72	90	59
						2
51.	Locate the Squat Cable (73), which is the			only	51
	remaining cable.	Attach the eyelet end of the
	Cable inside of the Long Base (120) with a 5/16” x
	2 1/2” Bolt (59), two 5/16” Washers (90), and a
	5/16” Nylon Locknut (86).
							73
								86
								90
								120
					59	90
52. Wrap the Squat Cable (73) over a 3 1/2” Pulley					52
	(78). Attach the Pulley, a Cable Trap (68), and two
	3/4” Spacers (124) between the indicated brackets					68	124
	on the Squat Slider (38) with a 3/8” x 3 1/4” Bolt					78		113
	(96) and a 3/8” Nylon Jamnut (113).		Make sure			124
	that the Cable Trap is turned to hold the Cable							38
	in the groove of the Pulley.
							96
							73

18