21. Remove both 3 112"Pulleys (24) from the | 2. | 1 |
| ||
bled Small Pulley Bracket (22). |
| |
|
|
Wrap the Butterfly Cable (73) around a 3 1/2" Pulley
(24)in the direction shown. Attach the Pulley to the
Small Pulley Bracket (22) with a 3/8" x 1 3/4" Bolt
(57)and a 3/8" Nylon Locknut (50). Make sure the
Small Pulley Bracket is oriented exactly as shown.
22.Wrap the Butterfly Cable (73) around a
(27)in the directionshown. Attach the
(53)and a 3/8" Nylon Locknut (50). Make aura the Large Cable Trap is oriented as shown.
23.Attach the ButterflyCable (73) to the bracket on the Right ButterflyArm (11) with a 3/8" x 1" Bolt (84) and two 3/8" Nylon Jamnuts (63). Note: The loop on the
Cable and the two Nylon Jamnuta must be mount- ed undemeath the welded bracket.
24.Identify the Ab Cable (74). It is approximately 224" long, and it has a ball on one end and a threaded
shaft on the other. You will start by attaching the end of the Cable with the ball.
Wrap the Ab Cable (74) around a 3 1/2" Pulley (24) in the direction shown. Place two Pulley Covers (47) over the Pulley, so that the slots in the Pulley Covers are placed over the Cable. Attach the Pulley and
Pulley Covers to the indicatedhole in the Butterfly Upright (1) with a 3/8" x 3 3/4" Bolt (59), two 3/8" Flat
Washers (48), and a 3/8" Nylon Jamnut (63). Make sure the Cable is between the Pulley and the welded pin on the Upright.
22
Bracket
l
73_
23
84 Bracket
47
_"63
12
