35. Attach the loop on the end of the Low Pulley Cable | 35 |
(75) to the indicated hole in the Small Leg Lever (41) | 41 | |
with a 3/8" x 2 3/4" Bolt (46), two 3/8" Flat Washers | ||
| ||
(48), and a 3/8" Nylon Jamnut (63). |
|
48
36.Remove a Pro Pulley (26) from the bag labeled "PULLEY BAG 2".
Identifythe Press Cable (72). It is approximately 389 1/2" long and it has a ball on one end and a threaded
shaft on the other. You will begin by attaching the end26 with the ball.
Wrap the Press Cable (72) around a Pro Pulley (26) in the direction shown. Attach the Pulley to the indi- cated hole in the Press Top Frame (9) with a 3/8" x
3 1/2" Bolt (56), a 3/8" Flat Washer (48), and a 3/8" Nylon Jamnut (63). Make sure the Cable is between the Pulley and the welded pin on the Press Top
37.Route the threaded end of the Press Cable (72)
around the 3 1/2" Pulley (24) that is already mounted on the Top Frame (9).
38.Wrap the Press Cable (72) around a 3 1/2" Pulley (24) in the direction shown. Attach the Pulley to the indicat- ed hole in the Press Upright (2) with a 3/8" x 3 3/4"
Bolt (59), a 3/8" Flat Washer (48) and a 3/8" Nylon
Locknut (50). Make sure the Cable Trap is oriented as shown.
59
16
