6.Press a 2" Square Inner Cap (28) half way into the top of the Front Leg (20), Press a 2" Square Inner Cap (28) into each end of the Small Leg Lever (41).
Attach the Bumper (40) to the indicated hole in the Front Leg (20) with a 1"Tap Screw (80).
Lubricate the 3/8" x 3 1/4" Bolt (62). Attach the Small Leg Lever (41) to the bracket on the Front Leg (20) with the Bolt and a 3/8" Nylon Jamnut (63). Do not overtighten the Nylon Jamnut; it must be easy to pivot the Leg Lever.
7.Press a 1" Square Inner Cap (98) into the small tube on the Press Upright (2).
Place the bracket on the lower end of the Press
Upright (2) over the indicated 5/16" x 2 1/2" Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16" Nylon Locknuts(64) onto the Bolts. Do not tighten the Nylon Locknuts yet.
Place the bracket on the lower end of the Support
Frame (3) over the indicated 3/8" x 2 1/2" Carriage Bolt (101) and the 3/8" x 4" Carriage Bolt (102) in the Press Base (6). Hand tighten a 3/8" Nylon Jamnut
(63)onto the 3/8" x 2 1/2" Carriage Bolt (101). Do not tighten the Nylon Jarnnut yet.
Note: Do not thread a Jamnut onto the 3/8" x 4" Carriage Bolt (102) yet.
Attach the Support Frame (3) to the Press Upright (2) with two 5/16" x 2 1/2" Carriage Bolts(92) and two
5/16" Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet.
8.Press a 2" Square Inner Cap (28) into the Press Top Frame (9).
Attach the Press Top Frame (9) to the indicated bracket at the top of the Press Upright (2) with two
5/16" x 2 3/4" Bolts(89), a Support Plate with 3 1/2" center holes (93), and two 5/16" Nylon Locknuts (64).
40
Lubricate
64
63
/
/
102
101
92
_>._28
7
