15. Attach each of the four Weight Guides (15) to the | 15 | |
Weight Top Frame (66) with a 3/8" x 3 3/4" Bolt (59), | ||
| ||
a 3/8" Flat Washer (48), and a 3/8" Nylon Locknut |
| |
(50). |
| |
Important: Go back and fully tighten all Nylon |
| |
Locknuts used in steps 1 through 15. |
|
16.Locate and open the parts bag labeled "ARM
ASSEMBLY."
Press a Plastic Bushing (100) onto each welded tube on the Press Frame (8).
Lubricate the 3/8" x 8" Bolt (52). Attach the Press Frame (8) to the welded tubes on the Press Base (6) with the Bolt and a 3/8" Nylon Locknut (50). Do not
overtighten the Nylon Locknut; it must be easy to pivot the Press Frame,
17.Press a 1 3/4" Square Inner Cap (35) into the top of a Press Arm (77). Press a 1" Round Inner Cap (76) into the indicated hole in the Press Arm.
Attach the Press Arm (77) to the bracket on the Press Frame (8) with two 5/16" x 2 112"Bolts(87) and two
5/16" Nylon Locknuts (64).
Repeat this step to assemble the second Press Arm (77, not shown).
48 50
Lubricate
52
35
64
77
10
