53.Wrap the Press Cable (72) around a 90mm Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (38) to the indicated hole on the right side of the Press Upright (5) with an M10 x 121mm Bolt (102) and an M10 Nylon Locknut (90). Note: Thread the Locknut only two turns onto the Bolt; another Pulley will be attached to the Bolt in step 57. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
54.Route the Press Cable (72) through the Press Frame (17) and around a 90mm Pulley (35) as shown. Attach the Pulley and a Cable Trap (38) to the indicated hole on the right side of the Leg Press Lever (14) with an M10 x 121mm Bolt (102) and an M10 Nylon Locknut (90). Note: Thread the Locknut only two turns onto the Bolt; another Pulley will be attached to the Bolt in step 56. Make sure the Cable Trap is posi- tioned to hold the Cable in the groove of the Pulley.
55.Wrap the Press Cable (72) around a
(34)in the direction shown. Attach the
(90).Note: the Press Seat Frame has five adjustment holes. The Pulley must attached at the second hole from the Leg Press Lever
(14).Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
56.Remove the M10 Nylon Locknut (90) used in step 54.
Wrap the Press Cable (72) around a 90mm Pulley (35) as shown. Slide a Cable Trap (38) and the Pulley onto the M10 x 121mm Bolt (102) in the Leg Press Lever (14). Properly tighten the M10 Nylon Locknut (90) onto the Bolt. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.
53 |
|
|
| 102 | 90 |
| 72 | |
|
| |
| 35 | 5 |
|
| |
|
| 38 |
54 |
|
|
102 | 72 |
|
35 | 38 | 90 |
|
| |
| 14 | 17 |
|
| |
55 |
|
|
| 115 |
|
| 97 |
|
| 12 | 37 |
| 72 | 34 |
14 | 90 | |
| ||
56 |
|
|
| 14 |
|
102 |
| |
|
| 90 72 |
|
| 38 35 |
21
