10.Press a 50mm Square Inner Cap (67) into the Press Top Frame (9).
Attach the Press Top Frame (9) to the indicated bracket at the top of the Press Upright (5) with two M8 x 66mm Bolts (89), a Medium Support Plate (109), and two M8 Nylon Locknuts (86). Do not tighten the Locknuts yet.
11.Identify the Left Weight Guides (27), which have welded rings near the bottom. Slide two Weight Bumpers (46) onto the Left Weight Guides. Insert the Left Weight Guides into the indicated holes in the Center Base (2).
Set the other two Weight Bumpers (46) over the indicated holes in the Center Base (2). Insert the Right Weight Guides (26) through the Weight Bumpers and into the holes in the Center Base.
Make sure the oval holes on the Right Weight Guides are on the top.
12.Attach the indicated Weight Guides (26, 27) to the Center Base (2) with two M10 x 67mm Bolts (82), four M10 Washers (97), and two M10 Nylon Locknuts (90).
10 |
| 89 |
|
|
|
| |
|
|
| 67 |
|
| 109 |
|
|
| 9 |
|
|
| 5 |
|
|
|
| 86 |
11 |
| Oval |
|
|
| Holes |
|
| 26 | 27 |
|
|
|
| |
|
|
| Welded |
|
|
| Rings |
|
| 46 |
|
|
| 2 |
|
12 |
| 26 |
|
|
|
| |
|
| 27 |
|
|
| 90 | 90 |
|
|
| |
|
|
| 97 |
| 82 | 97 |
|
|
|
| |
|
|
| 2 |
|
| 82 |
|
9
