57.Remove the M10 Nylon Locknut (90) used in step 53.
Route the Press Cable (72) through the Press Frame (17).
Wrap the Press Cable (72) under a 90mm Pulley
(35).Slide a Cable Trap (38) and the Pulley onto the M10 x 121mm Bolt (102) in the bottom of the Press Upright (5). Properly tighten the M10 Nylon Locknut (90) onto the Bolt. Make sure the Cable
Trap is positioned to hold the Cable in the groove of the Pulley.
58.Wrap the Press Cable (72) around a 90mm Pulley
(35)as shown. Slide a Cable Trap (38) and the Pulley onto the M10 x 92mm Carriage Bolt (112) in the Press Base (3). Secure the Pulley with an M10 Nylon Locknut (90). Make sure the Cable
Trap is positioned to hold the Cable in the groove of the Pulley.
59.Lay the Press Cable (72) in the bracket on the Center Base (2). Attach a 90mm Pulley (35) inside the bracket with an M10 x 45mm Bolt (94) and an M10 Nylon Locknut (90).
60.Wrap the Press Cable (72) over a 115mm Pulley (36). Attach the Pulley inside the indicated bracket on the Center Top Frame (8) with an M10 x 45mm Bolt (94) and an M10 Nylon Locknut (90).
57 |
|
|
|
|
|
|
|
| 38 |
|
|
|
| 72 |
| 5 | 102 | 35 | 90 |
| 17 |
|
| |
|
|
|
| |
58 |
|
|
|
|
| 72 | 90 |
|
|
|
| 35 |
| |
|
|
| 38 |
|
|
| 112 |
| |
|
| 3 |
|
|
59 |
|
|
|
|
72 | 35 | 94 |
| |
|
|
| ||
|
|
|
| |
|
|
| 90 |
|
|
|
| 2 |
|
60 |
| 72 |
|
|
8 | 90 |
|
| |
|
|
| ||
|
| 36 |
| |
|
|
|
| |
|
|
| 94 |
|
22
