ASSEMBLY
To make assembly easier, carefully read the following information and instructions:
•Assembly requires two persons.
•Because of its weight and size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clear- ance to walk around the weight bench as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•The following tools (not included) may be required for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver 
Assembly may be more convenient if you have a socket set, a set of
1.Before beginning assembly, make sure that you understand the information in the box above.
Orient the Left Base (4) so that the recessed holes are facing the floor.
Identify the Left Upright (6), which is marked with a “Left” sticker. Attach the Left Upright to the Left Base (4) with two M10 x 57mm Carriage Bolts (68) and two M10 Black Locknuts (66). Do not tighten the Black
Locknuts yet. Make sure that the nut is in the position shown.
Attach the Right Upright (7) to the Right Base (5) in the same way.
1 | Nut |
| 7 |
|
|
|
|
|
| ||
|
|
| Nut | 6 |
|
|
|
|
|
| |
|
| 5 | 66 | 66 |
|
|
|
|
| ||
|
| 4 | Recessed | ||
|
|
| |||
|
|
|
| 68 | Holes |
|
|
|
|
| |
2.Attach the Crossbar (12) to the Left Upright (6) with two M10 x 65mm Bolts (55), two M10 Black Washers (64), and two M10 Black Locknuts (66). Do not tighten the Black
Locknuts yet.
Attach the Crossbar (12) to the Right Upright (7) in the same way.
See steps
2
6
7 |
|
|
12 | 66 | 6 |
66 |
| 64 |
| 55 | |
|
|
