22.Insert the end of the High Cable (23) into the open end of the Weight Tube (63). Slide the Plastic Stabilizer (67) onto a 5/16” x 1 3/4” Bolt (72). Then, insert the Bolt into the hole near the top of the Weight Tube and through the end of the High Cable. Tighten a 5/16” Nylon Locknut (3) onto the Bolt. Make sure that the Plastic
Stabilizer is wrapped around the Weight Tube.
Insert the Weight Tube (63) into the center holes in the stack of Weights (25).
23.Identify the Low Cable (19). Wrap the Low Cable under the 3 1/2” Pro Pulley (77). Attach the Pulley to the Rocker Arm (32) with a 3/8” x 3 1/2” Bolt (16), a 3/8” Washer (9), and a 3/8” Nylon Locknut (21). Make sure that the end of the
Cable with the ball is on the indicated side of the Pro Pulley and that the Cable is between the Pro Pulley and the hook on the Rocker Arm.
24.Route the Low Cable (19) under the crossbar on the Press Frame (17).
Wrap the Low Cable (19) around a 3 1/2” Pulley
(15).Attach the Pulley and a Cable Trap (66) to the indicated side of the Rear Upright (56) with a 3/8” x 6” Bolt (64). Make sure that the Cable
Trap is turned to hold the Cable in place.
Slide another 3 1/2” Pulley (15) and Cable Trap
(66)onto the end of the 3/8” x 6” Bolt (64). Hand tighten a 3/8” Nylon Locknut (21) onto the Bolt.
22 |
|
| 23 |
| 67 |
| 3 |
| 63 |
| 25 |
| 72 |
23 |
|
| 16 |
| 77 |
| 19 |
| Hook |
21 | 32 |
9 | |
24 |
|
19 |
|
| 66 64 |
15 |
|
56 |
|
| 15 |
21 | 66 |
17 | |
| Crossbar |
12
