Weider WESY75742 Make sure the hexagonal hole in the Screw is, On the outside of the Bracket

11.	Insert the Resistance Bar (9) between the	11
	Crossbar Guides (15), and center it on the
	Crossbar Block (not shown).				15
	Press a Pulley Bracket (10) onto the Resistance					70
	Bar (9). Screw a 3/8” x 38mm Tension Screw
	(114) into the Pulley Bracket a couple of turns.
	Make sure the hexagonal hole in the Screw is								103
	on the outside of the Bracket.					9		54
	Attach a Tether (70) to the Pulley Bracket (10) at
	the upper hole, with an M10 x 64mm Button Bolt					80	10
	(80), an M10 Thick Washer (54), and an M10 Nylon								114
	Locknut (103).
	Repeat on the other side of the Resistance
	Bar (9). Then, tighten the lower M10 x 152mm	12
12.	Bolt (86) used in step 10.				13
	Hold a Large Pulley (14) inside the Upper Cable
	(121). Attach the Pulley to a Pulley Bracket (10)			10
	with an M12 x 58mm Button Bolt (87) and an M12		87
	Nylon Locknut (13). Make sure that the Cable is
	routed as shown in the CABLE DIAGRAM on			14
	page 18.				121
13.	Hold a Large Pulley (14) inside the Upper Cable	13
	(121). Attach the Pulley to the other Pulley
	Bracket (10) with an M12 x 58mm Button Bolt
	(87) and an M12 Nylon Locknut (13). Make sure						13
	that the Cable is routed as shown in the
	CABLE DIAGRAM on page 18.							114
	Tighten the two 3/8” x 38mm Tension Screws
	(114) an equal number of turns.				121 87		1410
14.	Attach the Leg Lever (56) to the Leg (5) with a	14
	Leg Station Pin (60). Slide a Cotter Pin (113) onto				5
	the Leg Station Pin.
				56				60	113
		10