2. Insert the connector of the Upper Wire Harness
(71) into the socket of the Lower Wire Harness
(117). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the con- nector over and then insert it.
Make sure that the connector and wires appear as shown in the inset drawing. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON- SOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the Mech Frame (6) into the Base Plate (1). Attach the Mech Frame to the Upright (2) with a 1/2” x 25mm Screw (85) and a 1/2” Lock Washer (12). Do not tighten the Screw yet.
Attach the Mech Frame (6) to the Base Plate (1) with four M10 Nylon Locknuts (103).
Tighten the 1/2” x 25mm Screw (85).
3.Press the Rail Cap (49) onto the Leg (5). Attach the Leg to the Rail (4) with two M10 x 64mm Button Bolts (80), four M10 Washers (106), and two M10 Nylon Locknuts (103).
4.Lubricate an M10 x 125mm Button Bolt (89) with grease. Attach the Rail (4) to the Row Plate (28) with the Bolt, two M10 Washers (106), two 31mm Spacers (30), and an M10 Nylon Locknut (103).
Do not overtighten the Locknut; the Rail must be able to pivot easily.
Tighten the Storage Knob (29) into the Row Plate (28) and the Rail (4).
2 |
| 6 | 12 |
|
|
|
| 85 | |||
|
|
|
| ||
| 71 |
| 117 |
| |
|
|
|
|
| |
| 103 |
|
|
|
|
| 2 | 1 |
| Black |
|
|
|
| Wire | 117 | |
|
| 103 |
|
| |
|
|
| 71 | Red | |
3 |
|
|
| Wire | |
103106 |
|
|
|
| |
| 4 |
| Holes on | ||
|
|
|
| ||
|
| 106 | this side | ||
| 49 | 80 |
| ||
|
|
|
|
| |
| 5 |
|
|
|
|
4 |
| 29 |
|
|
|
103 | 106 |
|
| 28 |
|
30 |
|
|
|
| |
| 4 | 30 | 106 Lubricate | 89 | |
7 |
|
| |||
|
|
|
|
| |
