ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the resist- ance system can be assembled successfully by most people. However, it is important to realize that the versatile resistance system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
• Assembly requires two persons.
• Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
• For help identifying small parts, use the PART IDENTIFICATION CHART.Note: Some small parts may have been
• | Tighten all parts as you assemble them, unless | |
• | instructed to do otherwise. |
|
As you assemble the resistance system, make | ||
| sure all parts are oriented as shown in the draw- | |
| ings. | and the fol- |
The included Allen wrenches | ||
lowing tools (not included) are required for | ||
assembly: |
| |
• | Two adjustable wrenches |
|
• | One rubber mallet |
|
• | One standard screwdriver |
|
• | One Phillips screwdriver |
|
• | Lubricant, such as grease or petroleum jelly, | |
| and soapy water. |
|
Assembly will be more convenient if you have a | ||
socket set, a set of | ||
wrenches, or a set of ratchet wrenches. |
1. | Before beginning assembly, make sure that | 1 |
|
| you have read and understand the informa- |
|
|
| tion in the box above. Refer to the PART |
| 2 |
| IDENTIFICATION CHART for help identifying |
| |
| small parts. |
|
|
| Pull the lower end of the Upper Wire Harness |
| 71 |
| (71) out of the hole in the back of the Upright (2). |
| |
| Attach the Upright (2) to the Base Plate (1) with |
|
|
| an M10 x 25mm Button Screw (88), an M10 |
| 88 |
| Washer (106), an M10 x 92mm Button Bolt (83), |
| |
| and an M10 Nylon Locknut (103). |
| 106 |
|
| 103 | |
|
| 1 | 83 |
|
|
| |
|
| 6 |
|