Replacing the TLP Print Head (Continued)
Assembly |
D |
C |
G |
B |
F |
A |
E |
The new print head comes with the clip (A) and ground screw (B) attached.
1.Detach the wire cover (C).
2.Detach the ribbon
3.Align the print head and bracket (E) to plug the left and right connectors into the black and white wire bundles.
4.Attach the ground wire (F) and secure it with the screw (B). Use a #2 Phillips driver to tighten it.
5.Insert the bracket pegs into the left side of the carriage.
6.Align the right side of the bracket and insert the print head clip (A) through the right side of the ribbon carriage into the bracket.
7.Slip the left end of the print head spring (G) into the left side of the ribbon carriage; then slide the right end into the other side. The angle of the "v" fits into the indent on top of the print head bracket.
8.Attach the ribbon
9.Attach the wire cover (C).
10.Clean the print head with the cleaning pen.
Reload media and ribbon. Plug in the power cord. Print a status report to ensure proper function.
| 33 |
