Replacing the Platen, Removal | Zebra Technologies TLP 2824 specs

Replacing the Platen

Removal

MOVIE

Open the printer and remove any media.

1. Using a pointed stylus (such as tweezers, small slot-head screwdriver, or razor-knife), unhook the tabs on the right and left sides. Then rotate them forward.

2. Lift the platen out of the printer’s bottom frame.

Assembly
Make sure the right bearing is on the shaft
of the platen.
1.	Align the platen with the gear to the
	left and lower it into the printer’s
	bottom frame.
2.	Rotate the tabs back and snap them
	into place.
30	980485-001A

Image 38

Zebra Technologies TLP 2824 manual Replacing the Platen, Removal, Assembly

Contents

Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Introduction Hello What’s in the Box? Inspecting the Printer Opening the printer Inspecting the Printer Closing the printer Related Documentation Reporting Damage Getting Started Modes of Printing Attaching Power Supply Adjusting the Roll Holders Loading Roll Media Placing the Roll in the Media Compartment Adjusting the Guides Loading Ribbon Install the Ribbon Supply RollInstall the Take-Up Core Attach and Tighten the Ribbon Feed Button Power SwitchOperator Controls Status Light Media Length Sensing Hooking Up the Printer and Computer Interface Cable Requirements Ethernet Interface Requirements USB Interface RequirementsParallel Interface Requirements Serial Interface Requirements Parallel Communications Communicating with the PrinterUniversal Serial Bus USB Communications Internal ZebraNet PrintServer II Ethernet Communications Command Serial Communications Adjusting the Print Width Adjusting the Print Quality Operation & Options Thermal Printing Replacing a Partially Used Transfer Ribbon Replacing SuppliesAdding a New Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Maintenance Cleaning Media Path Considerations Cleaning Card ConsiderationsPrint Head Considerations Lubrication Platen Considerations Removal AssemblyReplacing the Platen Replacing the Print Head Thermal-Transfer TLP Model Removal Assembly 980485-001A Troubleshooting What the Status Light is Telling You Printer Operation Media Handling Printed image does not look right Print Quality ProblemsNo print on the label Label format was sent to, but not recognized by, the printer Manual Calibration Resetting the Factory Default Values Communications Diagnostics Feed Button Modes Printer Condition Feed Button Action Interfaces Universal Serial Bus USB ConnectorAppendix Parallel Interface Host Looking into the Printer’s RJ-45 Modular Connector Internal Ethernet PrintServer Serial RS-232 Connector Serial RJ-11 Alternative Connector Printer 980485-001A Page Page