Weider WESY75742 user manual Do not tighten the Locknut yet, Do not tighten the Bolt yet

8.	Attach a Large Pulley (14) and the Pulley Plate	8
	(68) to the Upright (2) with an M12 x 62mm
	Button Bolt (81) and an M12 Nylon Locknut (13).			68	13
	Do not tighten the Locknut yet.
				14
		81		2
9.	Pull the Upper Cable (121), which is attached	9
	inside of the Mech Frame (not shown), up
	between the Upright (2) and the Pulley Plate (68).				11	121
	Attach another Large Pulley (14) to the Upright (2)			90
	and Pulley Plate (68) with an M12 x 62mm Button
	Bolt (81) and an M12 Nylon Locknut (13). Make			13
	sure that the Upper Cable (121) is between the
	two Pulleys.	81		68	14
	Hold the 38mm Spacer (90) inside the loop of the
	Upper Cable (121), and between the Upright (2)			2
	and the Pulley Plate (68). Attach the Spacer with
	an M10 x 58mm Button Screw (11). Make sure
	the ends of the Cable do not wrap around
	each other below the Spacer and the Large
	Pulleys (14) used in steps 8 and 9 (refer to the
	CABLE DIAGRAM on page 18).
	Tighten the M12 Nylon Locknuts (13) used in
	steps 8 and 9.
10.	Attach a Small Guide Spacer (18), a Large Guide	10
	Spacer (17), and two Crossbar Guides (15) to the
	Upright (2) with an M10 x 152mm Bolt (86).
	Pull the Upper Cable (121) up between the		17
	Crossbar Guides (15). Press the metal cover on	18		86
	the Cable into the groove in the Crossbar Block
	(16). Attach a Small Guide Spacer (18), the		15	Metal
	Crossbar Block, the two Crossbar Guides (15), an				54
	M10 Thick Washer (54), and the two Tethers (70)	2	121	Cover
	to the Upright (2) with another M10 x 152mm Bolt					86
	(86). Do not tighten the Bolt yet.				70
		18	16	Groove
		9