5.Rotate the corner of the assembly away from the product until you can see the PCA, and then remove the assembly from the product.

Reinstallation tip When the laser/scanner is correctly positioned in the chassis, the plastic parts which protrude at the front and rear of the product will be firmly seated against the locator tabs on the chassis. Verify that the assembly is correctly seated, and then install the spring.

Figure 2-184Remove the laser/scanner assembly (C/Bk) (5 of 5)

1

2

Reinstall the protective glass cleaner (PGC) actuators

1.The following figure shows a dislodged PGC actuator.

TIP: If the actuator and spring are only slightly dislodged, you might be able to easily push them back into place.

Figure 2-185Reinstall the PGC actuators (1 of 5)

ENWW

Internal assemblies 193

Page 225
Image 225
HP Enterprise CC490A 184Remove the laser/scanner assembly C/Bk 5, Reinstall the protective glass cleaner PGC actuators