HP Enterprise CC490A manual Remove the ITB motor

ITB motor

Before proceeding, remove the following components:

●Upper-left cover. See Upper-left cover on page 96.

●Power-supply cover. See Power-supply cover on page 98.

●Front-top cover. See Front-top cover on page 100.

●Rear-top cover. See Rear-top cover on page 102.

●Left cover. See Left cover on page 99.

●Rear cover. See Rear cover on page 112.

●Interconnect board (ICB). See Interconnect board (ICB) on page 153.

●Low-voltage power supply. See Low-voltage power supply (LVPS) on page 157.

●DC controller PCA. See DC controller PCA and tray on page 161.

●High-voltage power supply upper. See High-voltage power supply upper (HVPS-T) on page 196.

Remove the ITB motor

▲Remove three screws (callout 1), disconnect one connector (callout 2), and then remove the motor (callout 3).

Figure 2-195Remove the ITB motor (1 of 2)

1

2

3

202 Chapter 2 Removal and replacement ENWW