HP Enterprise CC490A manual Refresh YES, Link Speed Auto 10T Half 10T Full 100TX Half 100TX Full

Table 3-13Embedded Jetdirect menu (continued)

Item	Sub-item	Sub-item	Sub-item	Description
		REFRESH	YES	When viewing the ping test results, this item
			NO*	updates the ping test data with current
				results. Select YES to update the data, or
				NO to maintain the existing data. However, a
				refresh automatically occurs when the menu
				times out or you manually return to the main
				menu.

LINK SPEED	AUTO*
	10T HALF
	10T FULL
	100TX HALF
	100TX FULL
	100TX AUTO
	1000T FULL

The link speed and communication mode of the print server must match the network. The available settings depend on the product and installed print server. Select one of the following link configuration settings:

CAUTION: If you change the link setting, network communications with the print server and network product might be lost.

AUTO: The print server uses auto- negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10T HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)

10T HALF: 10 Mbps, half-duplex operation.

10T FULL: 10 Mbps, full-duplex operation.

100TX HALF: 100 Mbps, half-duplex operation.

100TX FULL: 100 Mbps, full-duplex operation.

100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.

1000T FULL: 1000 Mbps, full-duplex operation.

ENWW Tools for troubleshooting 341