HP Enterprise CC490A manual Exhaust fan and fan duct, Remove the exhaust fan and fan duct

Exhaust fan and fan duct

Before proceeding, remove the following components:

●Formatter. See Formatter PCA on page 78.

●Upper-left cover. See Upper-left cover on page 96.

●Power-supply cover. See Power-supply cover on page 98.

●Left cover. See Left cover on page 99.

●Front-top cover. See Front-top cover on page 100.

●Rear-top cover. See Rear-top cover on page 102.

●Rear cover. See Rear cover on page 112.

●Interconnect board (ICB). See Interconnect board (ICB) on page 153.

●Low-voltage power supply. See Low-voltage power supply (LVPS) on page 157.

●High-voltage power supply lower. See High-voltage power supply lower (HVPS-D) on page 163.

Remove the exhaust fan and fan duct

1.Remove two screws (callout 1), disconnect two connectors (callout 2), and then remove the exhaust fan and duct (callout 3) from the product.

Figure 2-149Remove the exhaust fan and fan duct (1 of 3)

2

1

3

ENWW Internal assemblies 169