HP Enterprise CC490A manual Install Color Cartridge, Install Fuser, Install Supplies, Fontsdata

Table 3-14Control-panel messages (continued)

Description	Recommended action
Incorrect	The PIN is incorrect.	Use the up arrow and down arrow
		buttons to enter the correct PIN.
Initializing	The product is starting.	No action is necessary. Please wait until the
		Ready message appears on the display.
Initializing permanent storage	Displayed when the product is turned on to	No action is necessary.
	show that permanent storage is being
	initialized.

INSTALL <COLOR> CARTRIDGE	The print cartridge has been removed or has
	been installed incorrectly.

Replace or reinstall the print cartridge correctly to continue printing. See Print cartridges on page 74.

INSTALL FUSER	The fuser has been removed or installed	CAUTION: The fuser can be hot while the
	incorrectly.	product is in use. Wait for the fuser to cool
		before handling it.
		1.	Open the right door.
		2.	Install or adjust the fuser.
		3.	Close the right door.
INSTALL SUPPLIES	More than one supply is missing or is installed	Press the OK button to identify which supplies
	incorrectly.	need to be replaced. Press the OK button a
		second time for more information about the
		specific supply. Insert the supply item or
		make sure the installed supply item is fully
		seated.
INSTALL TRANSFER UNIT	The transfer unit has been removed or	1.	Open right door.
	installed incorrectly.	2.	Install the transfer unit.
		3.	Close the right door.
		4.	If the error persists, use the manual
			sensor test to check the ITB alienation
			sensor (SR9). See Manual sensor test
			(special-mode test) on page 246. This
			sensor also detects the presence of the
			ITB.
		5.	Reconnect the ITB alienation sensor
			connector J78, and the connector J127
			on the DC controller PCA.
INSUFFICIENT MEMORY TO LOAD	The product does not have enough memory	To continue without this information, press
FONTSDATA	to load the data (for example, fonts or	the OK button . If the message persists, add
	macros) from the location specified.	more memory.
Internal Disk Not Functional	The internal disk is not working correctly.	Replace the internal hard drive. See Hard
		drive on page 79.
LOAD TRAY 1 [TYPE] [SIZE]	Tray 1 is empty.	Load Tray 1 with the requested paper.
		If the paper is already in the Tray 1, press the
		help button , and then press the OK button
		to print.

To use another tray, remove paper from Tray 1, and then press the OK button to continue.

362 Chapter 3 Solve problems ENWW