HP Enterprise CC490A manual 115Remove the delivery assembly 3 Removal and replacement

2.Remove two screws (callout 1), and then remove the paper guide (callout 2).

NOTE: Duplex models only: press the duplex solenoid (callout 3) to create enough clearance to remove the paper guide (callout 2).

TIP: The fuser delivery sensor is installed on the rear of the paper guide. Leave the sensor attached to the guide, and rotate the paper guide toward the rear of the product to access the delivery assembly.

Figure 2-114Remove the delivery assembly (2 of 7)

2

3

1

3.Release the wire harness from the guides (callout 1), and then disconnect one connector (callout 2).

Figure 2-115Remove the delivery assembly (3 of 7)

2

1

146 Chapter 2 Removal and replacement ENWW