HP Enterprise CC490A manual Tray-pickup assembly, Remove the tray-pickup assembly

Tray-pickup assembly

Before proceeding, remove the following components:

●Formatter. See Formatter PCA on page 78.

●Secondary transfer assembly. See Secondary transfer assembly on page 119.

●Intermediate transfer belt (ITB). See Intermediate transfer belt (ITB) on page 92.

●Upper-left cover. See Upper-left cover on page 96.

●Power-supply cover. See Power-supply cover on page 98.

●Left cover. See Left cover on page 99.

●Front-top cover. See Front-top cover on page 100.

●Rear-top cover. See Rear-top cover on page 102.

●Right-rear cover. See Right-rear cover on page 110.

●Rear cover. See Rear cover on page 112.

●Registration assembly. See Registration assembly on page 128.

●Interconnect board (ICB). See Interconnect board (ICB) on page 153.

●Low-voltage power supply. See Low-voltage power supply (LVPS) on page 157.

●High-voltage power supply lower. See High-voltage power supply lower (HVPS-D) on page 163.

Remove the tray-pickup assembly

NOTE: This task requires that you remove three feed guides on the right side of the product before you can remove the tray-pickup assembly.

1.Remove one screw (callout 1), and then disconnect two connectors (callout 2). Figure 2-164Remove the tray-pickup assembly (1 of 11)

2

1

180 Chapter 2 Removal and replacement ENWW