HP Enterprise CC490A manual RAM Disk Device Failure, RAM Disk File Operation Failed

Table 3-14Control-panel messages (continued)

Description	Recommended action
Processing...	The product is currently processing a job but	No action is necessary.
	is not yet picking pages. When paper motion
	begins, this message will be replaced by a
	message that indicates which tray the job is
	being printed from.
Processing...	The product is processing a cleaning page.	No action is necessary.
CLEANING PAGE
Processing... copy <X> of <Y>	The product is currently processing or	No action is necessary.
	printing collated copies. The message
	indicates that copy X of Y total copies is
	currently being processed.
Processing... from tray <X>	The product is actively processing a job from	No action is necessary.
	the designated tray.
RAM DISK DEVICE FAILURE	The specified device has failed.	Press the OK button to clear.
To clear press OK
RAM DISK FILE OPERATION FAILED	A PJL file system command attempted to	Press the OK button to clear.
To clear press OK	perform an illogical operation.
RAM DISK FILE SYSTEM IS FULL	A PJL file system command could not store	Press the OK button to clear.
To clear press OK	something on the file system because the file
	system was full.
RAM DISK IS WRITE PROTECTED	The file system device is protected and no	Press the OK button to clear.
To clear press OK	new files can be written to it.
RAM DISK NOT INITIALIZED	This file-storage component must be	Use the HP Embedded Web Server or
	initialized before use.	HP Web Jetadmin to initialize the component.
Ready	The product is online and ready for data. No	No action is necessary.
	status or product attendance messages are
	pending at the display.
Ready	The product is online and ready.	No action is necessary.
IP ADDRESS
Ready Diagnostics mode	The product is in Diagnostics mode.	To stop Diagnostic mode, press the Stop
To exit press		button .
Receiving Upgrade	A firmware upgrade is in progress.	Do not turn the product off until the product
		returns to Ready.
Remove all print cartridges	The product is testing the transfer unit	To perform the test, remove all the print
To exit press	assembly.	cartridges. To cancel the test, press the stop
		button .
Remove at least one print cartridge	The product is testing the print-cartridge	To perform the test, remove at least one print
To exit press	motor.	cartridge. To cancel the test, press the stop
		button .
REMOVE CARTRIDGE LOCKS	The cartridge shipping locks were not	1. Open the front door.
	removed before you turned the product on.	2. Remove the orange cartridge locks.

366 Chapter 3 Solve problems ENWW