HP Enterprise CC490A manual Tray-pickup drive assembly, Remove the tray-pickup drive assembly

Tray-pickup drive assembly

Before proceeding, remove the following components:

●Formatter. See Formatter PCA on page 78.

●Upper-left cover. See Upper-left cover on page 96.

●Power-supply cover. See Power-supply cover on page 98.

●Left cover. See Left cover on page 99.

●Front-top cover. See Front-top cover on page 100.

●Rear-top cover. See Rear-top cover on page 102.

●Right-front cover. See Right-front cover on page 103.

●Rear cover. See Rear cover on page 112.

●Right-rear cover. See Right-rear cover on page 110.

●Interconnect board (ICB). See Interconnect board (ICB) on page 153.

●Low-voltage power supply. See Low-voltage power supply (LVPS) on page 157.

●High-voltage power supply lower. See High-voltage power supply lower (HVPS-D) on page 163.

Remove the tray-pickup drive assembly

NOTE: To remove the pickup motor only, see Pickup motor on page 172.

1.Release two tabs, and then remove the power-supply fan. Figure 2-161Remove the tray-pickup drive assembly (1 of 3)

178 Chapter 2 Removal and replacement ENWW