
30.Wrap the Low Cable (9) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the Front Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (19), a Cable Trap (66), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon Jamnut (63).
Make sure the Cable Trap (66) is positioned as shown and that the Pulley (35) is not rubbing on the Cable Trap.
Attach the loop on the end of the Low Cable (9) to the 3/8Ó x 2 1/4Ó Eyebolt (44) with a Cable Clip (73). Note: Cable Clips are located in the parts bag labeled
ÒSEAT ASSEMBLY.Ó
Seat Assembly
31.Open the parts bag labeled ÒSEAT ASSEMBLY.Ó
Attach the Backrest (41) to the Front Upright (42) with two 1/4Ó x 2 1/2Ó Screws (43) and two 1/4Ó Flat Washers (90).
32.Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4Ó x 3/4Ó Screws (17).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indicat- ed hole in the Seat Frame (36). Tighten a 1/4Ó Nylon Locknut (89) with a 1/4Ó Flat Washer (90) onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4Ó Flat Washer (90) and a 1/4Ó x 2Ó Bolt (71).
30 | 42 |
|
|
|
|
| |
| 63 |
|
|
35 | 55 |
|
|
|
|
| |
|
|
| 9 |
19 | 66 |
| 73 |
|
|
| 44 |
|
| 12 |
|
31 |
|
|
|
|
|
| 42 |
| 43 |
|
|
| 90 |
| 41 |
|
|
| |
| 43 |
|
|
32 |
|
| 13 |
|
|
| |
|
| 36 | 38 |
|
| 37 | |
|
|
| |
|
|
| 17 |
| 90 |
| 90 |
| 71 |
| |
|
| 89 |
14