8.Attach the indicated end of the Console Cord (83) to the indicated end of the wire bundle. Make sure that the Console Cord is attached exactly as shown.
9.Feed both Wire Ties (23) into the Wire Tie Blocks (82) that are
Note: The other end of the wire bundle will be attached to a shroud in a later step. Make sure that some slack is left between the wires and the Weight Mechanism (26, not shown) for this pur- pose.
10.Press a 1 1/2Ó Square Inner Cap (33) into the end of the Seat Frame (36).
Insert two 5/16Ó x 2 3/4Ó Bolts (67) through the Support Plate (27) and the indicated holes in the Front Upright (42). Place the mounting bracket on the Seat Frame (36) over the two Bolts. Tighten a 5/16Ó Nylon Locknut (53) onto each Bolt. Make sure the
Support Plate (27) is oriented as shown.
Press the Angle Cap (62) onto the end of the rod on the Support Plate (27). Make sure that the Angle
Cap is angled as shown in the inset drawing.
Arm Assembly
11.Open the parts bag labeled ÒARM ASSEMBLY.Ó
Press a Plastic Bushing (7) onto each welded tube on the Press Frame (12).
Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the Press Frame (12) to the Base (8) with the Bolt and a 3/8Ó Nylon Locknut (57).
8 |
|
|
| 26 |
|
83 |
|
|
| Wires |
|
9 |
|
|
| Wires |
|
82 |
| 8 |
23 |
|
|
10 | 42 |
|
Rod |
| |
67 |
|
|
62 | Bracket |
|
|
| |
27 | 53 |
|
|
| |
| 36 | 33 |
|
| |
| 53 |
|
11 |
|
|
| 12 |
|
| 59 Lubricate | |
57 |
|
|
| 7 |
|
| Welded Tubes | |
8 |
|
|
8
