33.Press two 3/4Ó Round Inner Caps (34) into each Pad Tube (28).
Insert one Pad Tube (28) into the Seat Frame (36). Slide a Foam Pad (30) onto each end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg Lever
(29). Slide a Foam Pad (30) onto each end of the Pad Tube.
34.Attach the Curl Pad (24) to the Curl Post (10) with two 1/4Ó x 3/4Ó Screws (17).
Slide the Curl Post (10) onto the Seat Frame (36) so each of the welded brackets is between the Seat Frame and the bracket on the Leg lever (29). Secure the Curl Post with the 5/16Ó x 2Ó Knob (72).
Make sure the Leg Lever (29) can be turned freely after the Curl Post (10) is mounted.
35.Insert the three 1 1/2Ó Square Inner Caps (33) into the Console Base (61).
Attach the Console Upright (94) to the Console Base (61) with two 1/4Ó x 5/8Ó Screws (95).
Attach the Console (39) to the the Console Upright (94) with four #8 x 1/2Ó Screws (87).
36.Plug the end of the Console Cord (83) into the Console (39).
Note: When the Shroud (not shown) is attached in step 39, the Console Cord (83) should be pressed between the bottom of the Shroud and the Base (8).
33 |
| 36 | 30 |
|
| ||
|
| 28 | 34 |
|
| 29 | |
|
| 34 | 34 |
|
|
| |
|
|
| 30 |
| 30 |
| 28 |
| 30 | ||
|
| ||
|
| 34 |
|
34 |
|
|
|
|
| 17 |
|
|
|
| 24 |
|
|
| 10 |
|
| 72 | Welded |
|
| 36 | Brackets |
|
| 29 |
|
35 |
|
|
|
|
|
| 39 |
|
| 94 |
|
|
| 87 |
|
|
| 95 | 33 |
|
| 61 | 95 |
|
|
| |
| 33 |
|
|
|
|
| 33 |
36 |
|
|
|
|
| 39 |
|
|
| 83 | 8 |
15
