Weider WESY92190 manual Trouble-shooting and Maintenance, Tightening the Cables

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use sol- vents.

Note: If any of the following adjustments are made to the weight system, the weight mechanism must also be adjusted. Please refer to steps 38a to 38g on pages 16 and 17 to perform these adjustments.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight sys- tem, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened. Slack can be removed from the cables in several different ways:

Slack can be removed by moving the ÒVÓ-Pulley (6) to one of the other holes in the welded tube on the Seat Frame (36). To do this, remove the 3/8Ó x 3 1/4Ó Bolt (69), Cable Trap (66), 3/8Ó Flat Washer (55) and 3/8Ó Nylon Locknut (63). Move the ÒVÓ-Pulley and re-attach it with the Bolt, Washer, Cable Trap and Locknut.

Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable and re-install it.

If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

1

36

Welded

Tube

63

55

6

66

69

Additional slack can be removed by using the Pulley Plates (31). The Pulley Plates have several sets of adjust- ment holes. By moving one or both pulleys to a different set of holes, the cables will be tightened.

To move a Pulley, remove the 3/8Ó Nylon Jamnut (63) and the 3/8Ó x 1 1/2Ó Bolt (60). Remove the Cable Trap (66) and the Pulley (35) from the Pulley Plates (31). Re-attach the Pulley and the Cable Trap to the appropriate hole in the Pulley Plates. Note: Begin by moving one Pulley to the second adjustment hole. If the Cables are still too loose, move the same Pulley to the third hole. If addi- tional adjustment is needed, move the second Pulley until the Cables are tight.

	Adjustment
31	Holes
	66
60
	63
	35

22