Weider WESY99490 manual Small Pulley Bracket is oriented exactly as shown

21.Remove both 3 1/2Ó Pulleys (24) from the pre-assem- bled Small Pulley Bracket (22).

Wrap the Butterfly Cable (73) around a 3 1/2Ó Pulley

(24)in the direction shown. Attach the Pulley to the Small Pulley Bracket (22) with a 3/8Ó x 1 3/4Ó Bolt

(57)and a 3/8Ó Nylon Locknut (50). Make sure the

Small Pulley Bracket is oriented exactly as shown.

22.Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley

(27)in the direction shown. Attach the ÒVÓ-Pulley and a Large Cable Trap (32) to the bracket on the back of the Butterfly Upright (1) with a 3/8Ó x 2 1/2Ó Bolt

(53)and a 3/8Ó Nylon Locknut (50). Make sure the

Large Cable Trap is oriented as shown.

23.Attach the Butterfly Cable (73) to the bracket on the Right Butterfly Arm (11) with a 3/8Ó x 1Ó Bolt (84) and two 3/8Ó Nylon Jamnuts (63). Note: The loop on the

Cable and the two Nylon Jamnuts must be mount- ed underneath the welded bracket.

24.Identify the Ab Cable (74). It is approximately 224Ó long, and it has a ball on one end and a threaded shaft on the other. You will start by attaching the end of the Cable with the ball.

Wrap the Ab Cable (74) around a 3 1/2Ó Pulley (24) in the direction shown. Place two Pulley Covers (47) over the Pulley, so that the slots in the Pulley Covers are placed over the Cable. Attach the Pulley and Pulley Covers to the indicated hole in the Butterfly Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (59), two 3/8Ó Flat Washers (48), and a 3/8Ó Nylon Jamnut (63). Make sure the Cable is between the Pulley and the welded pin on the Upright.

21
		73
		24
			50
	57
			22
22
53		Bracket
			50
	27
73	32
		1
23
		84
		Bracket
11	63
		73
24
59
	48
		47
	Pin
	74	24	63
		48
	1

12