Weider WESY99490 manual Trouble-shooting and Maintenance, Tightening the Cables

Models: WESY99490

1 33
Download 33 pages 49.86 Kb
Page 26
Image 26
Trouble-shooting and Maintenance

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym. Replace any worn parts immediately. The home gym can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

Tightening the Cables

Woven cable, the type of cable used on the home gym, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

Note: If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re- install it.

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

Slack can be removed from the cables in several different ways:

The Adjustable Pulley Plates (23) have several sets of adjustment holes. By moving one or both pulleys (24) to a different set of holes, you will tighten the cables.

To move a Pulley (24), remove the 3/8Ó Nylon Locknut

(50)and the 3/8Ó x 2Ó Bolt (54). Remove the Cable Trap

(25)and Pulley from the Adjustable Pulley Plates (23). Re-attach the Pulley and Cable Trap to the appropriate adjustment hole in the Pulley Plates. Note: Begin by moving one Pulley to the second adjustment hole. If the cables are still too loose, move the same Pulley to the third hole. If additional adjustment is needed, move the other Pulley until the cables are tight.

Slack can be removed form the Press Cable (72) by mov- ing one or both of the ÒVÓ-Pulleys (27) on the Press Cable.

One ÒVÓ-Pulley (27) is attached to the small tube on the Press Upright (2). There are three free holes in the small tube, and you can move the ÒVÓ-Pulley to any one of them to tighten the cables. Start by moving the ÒVÓ-Pulley one hole, and then one more, as needed.

The second ÒVÓ-Pulley (27) is attached to the Press Seat Frame (7). There are five adjustment holes in the Seat Frame. By moving the ÒVÓ-Pulley closer to the Press Upright (2), you will tighten the cables. By moving it fur- ther away from the Upright, you will loosen the cables.

23 Tightening the CablesManual background Adjustment Holes

54

 

 

50

 

 

 

 

24

 

25

 

 

 

 

 

 

2

7

 

 

 

72

 

27

27

 

 

 

 

 

.

26

Page 26
Image 26
Weider WESY99490 manual Trouble-shooting and Maintenance, Tightening the Cables