Weider WESY99490 manual Miscellaneous Assembly, Leg Press Plate must be on the upper edge

52.Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (45) through the center hole in a Seat Plate (65). Attach the Seat Plate to a Seat (13) with two 1/4Ó x 3/4Ó Bolts (49).

Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (45) into the indi- cated hole in the Butterfly Seat Frame (14) and secure it with a 1/4Ó Flat Washer (71) and a 1/4Ó Nylon Locknut (68). Secure the other end of the Seat

(13)with a 1/4Ó x 2 1/2Ó Bolt (79) and a 1/4Ó Flat Washer (71).

Attach the other Seat (13) to the Press Seat Frame (7, not shown) in the same manner.

Miscellaneous Assembly

53.Press a 3/4Ó Round Inner Cap (43) into each end of the two Pad Tubes (42).

Insert one Pad Tube (42) into the indicated hole in the Front Leg (20). Slide a Foam Pad (30) onto each end of the Pad Tube.

Insert the other Pad Tube (42) into the indicated hole in the Small Leg Lever (41). Slide a Foam Pad (30) onto each end of the Pad Tube.

54.Press a 1 3/4Ó Square Inner Cap (35) into the indicat- ed end of the Adjustment Tube (90).

Attach the Adjustment Tube (90) to the bracket (not visible in the drawing) on the back of the Leg Press Plate (55) with a 5/16Ó x 2 1/2Ó Bolt (87), two 5/16Ó Washers (36), and a 5/16Ó Nylon Locknut (64).

Attach the Leg Press Plate (55) to the Leg Press Lever (83) by placing the Adjustment Tube (90) into the bracket on top of the Leg Press Lever and secur- ing it with the Lock Pin (91). Note: The lip on the

Leg Press Plate must be on the upper edge.

52
	13		45
	65
	14	49
		71
			68
	71	79
53	30
	43	42
			30
	41
	43
	30		43
			20
		42
			30	43
54		91
			35
	36
	64
			90
			87
		36
	55
	83

21