1 | EG, PEG, EGH |
|
Installation (continued)
Figure 5 Front and back base panels | Figure 6 Burner drawer assembly |
Installation of drawer assembly and front access panel and back base channel
steps 2 and 3)
1.The drawer assembly consists of the burner drawer, main burners, gas manifold, pilot burner, etc. See Figures 6, 7 and 8 for installation.
2.Check for proper orifice sizing from chart below.
Proper orifices must be used. Failure to do so will cause severe personal injury, death or substantial property damage.
3. Level and straighten burners.
Burners must be properly seated in slots in back burner support with openings facing up. Gas orifices must inject down center of burner. Failure to properly seat burners will result in severe personal injury, death or substantial property damage.
4.Install front access panel and back base channel. See Figure 9.
5.Install rollout thermal fuse element with wire terminals facing up on front access panel of EG
Figure 7 Pilot burner location
Figure 8 Burner drawer installation
Figure 9 Access panel
Part Number | 7 |
