4.Remove the Lock Knob (54) from the Lock Pin (59). Press the Lock Knob Sleeve (55) into the left Upright (61).
Make sure that the Lock Pin Collar (57) and the Spring (56) are on the Lock Pin. Insert the Lock Pin into the left Upright (61) and tighten the Lock Knob onto the Lock Pin.
5.Note the location of the 75 ohm antenna terminal on the treadmill (for clarity, the treadmill is shown in the storage position). For the television to operate prop- erly, an antenna, a CATV cable, or a VCR must be con- nected to the 75 ohm antenna terminal.
If you are using an antenna, it must be properly con- nected and adjusted for optimal reception. Refer to AN- TENNA CONNECTIONS on pages 12 and 13 to properly connect an antenna.
If you are using a CATV cable, refer to CATV CABLE CONNECTION on page 13 to properly connect the cable.
If you are using a VCR, refer to HOW TO CONNECT A VCR on page 17 to properly connect the VCR. The VCR must be turned on, a videocassette must be properly inserted, and the VCR must be playing. Refer to your VCR userÕs manual for operating instructions.
6.The console requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, first open the Battery Cover (98) as shown. Press two batteries into the battery compartment, with the negative ends of the batteries (marked ÒÐÓ) touching the springs. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown. Be sure that the tab locks into place.
7.Make sure that all parts are tightened before you use the treadmill. Note: The ratchet screws on the adjustable rear incline are factory set and should not be adjusted.
Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet from damage, place a mat under the treadmill.
8
4 |
54 |
56 |
57 |
59 |
55 |
61 |
5 |
75Ohm Antenna Terminal
6 | Batteries |
| |
| 98 |
| Battery |
| Cover Tab |
7 |
|
Ratchet
Screws 
