Westell Technologies 36R570 manual Wirespeed PRO Installation, Single-User Setup

ADSL WireSpeed Pro 36R570 Proxy Router

User Guide

WIRESPEED PRO™ INSTALLATION

The WireSpeed Pro Proxy Router operates up to 300 feet (91.4 meters) from a PC or Ethernet hub over 100-Ohm, Category 5 cable.

For installation on a wall surface, follow the instructions below. If you are not installing the unit on a wall surface, proceed to the section on Single or Multiple-User Setup.

Installing on Hollow Drywall Surfaces (Optional)

To mount the WireSpeed Pro to a wall:

1.Obtain two pan-head screws (one #8 and one #6) and two #4 - #8 wall anchors (not provided).

2.Place the WireSpeed Pro against the wall where it is to be mounted, note and mark the upper keyhole slot and screw location.

3.Drill a 3/16” hole for the upper anchor and insert the anchor and larger (#8) screw until the face of the screw is approximately 3/16” from the wall.

4.Test fit the unit on the screw, and adjust the screw depth for a sliding fit.

5.With a pencil, mark the opening in lower mounting tab. Remove the unit from the wall.

6.Drill a 3/16” hole for the lower anchor and insert anchor. Hang the unit on the upper screw.

7.Insert the smaller (#6) screw through the hole in the lower mounting tab.

8.Tighten the lower screw lightly with a screwdriver. Do not overtighten.

Single-User Setup

Refer to the wiring diagrams shown in Figure 1 and Figure 3.

1.Connect the power supply cord to the power connector on the side of the unit and plug it into the wall power receptacle.

2.Connect a standard RJ-11 telephone cable from the LINE connector to the ADSL-equipped phone line.

3.Connect the straight 10Base-T cable (included with this package) to the ETHERNET connector on the side of the unit to the interface on the computer. A crossover cable may be required when connecting to other equipment, such as an Ethernet hub. (See “Multiple-User Setup” below.)

4.Turn the power switch ON.

5.The Ready LED should be a solid green indicating that the power self-test has successfully completed and the unit is synchronized with the ADSL line card. It may take up to 70 seconds for the unit to synchronize with the central office ADSL unit.

030-300153A 6 WireSpeed Pro Installation