Whirlpool 2195258 manual Removing the base grille, Connecting to refrigerator

Connecting to refrigerator

1.Disconnect the tube clamp on the back of the product and insert copper tubing through

the clamp as shown at the right. Attach	Copper
the copper tube to the valve inlet using a
	tubing
compression nut and sleeve as shown.	clamp
Tighten the compression nut. Do not over-
tighten. Reattach the tube clamp and tube
to the back of the cabinet. Move to step 2.

2.Turn shut-off valve ON. CHECK FOR LEAKS. TIGHTEN ANY CONNECTIONS (INCLUDING CONNECTIONS AT THE VALVE) OR NUTS THAT LEAK.

3. The ice maker is equipped with a built-in	Water
water strainer. If local water conditions	valve
require periodic cleaning or a well is your
source of water supply, a second water
strainer should be installed in the 1⁄4-inch
water line. Obtain a water strainer from
your nearest appliance dealer. Install at
either tube connection.

4.Reconnect electrical supply to refrigerator.

Use only 1⁄4-inch copper tubing from cold water line

Mounting screw

Copper tubing

1⁄4-inch compression nut and sleeve

Water inlet fitting

Removing the base grille

wWARNING

Burn Hazard

Do not touch refrigeration tubes near defrost pan.

Doing so can result in burns.

To remove the base grille:

1.Open the refrigerator door.

2.Grasp the grille with both hands.

3.Push down on the top edge of the grille to release the top clips.

4. Roll grille toward you to release top clips.

5. Pull grille away from the refrigerator.

NOTE: Do not remove the Tech Sheet fastened behind the grille.

Condenser Defrost

coilspan

22