Whirlpool FGS385B PROBLEM Burner fails to light, Burner flames are uneven, Possible Cause

PROBLEM

Burner fails to light

Burner flames are uneven

Burner flames lif-t off ports, are yellow, or are noisy when turned off

Burner makes popping noise when on

Control knob(s) will not turn

Self-Cleaning cycle will not operate

POSSIBLE CAUSE

The power cord is not plugged into a live circuit with proper voltage.

A household fuse has blown or a circuit breaker has tripped.

Burner ports are clogged.

Burner ports are clogged.

Air/gas mixture is incorrect.

Burner is wet from washing.

You are not pushing in before turning.

The Oven Selector and Oven Temperature Control are not set to CLEAN.

The range clock does not show the correct time of day.

The Lock Lever is not in the CLEAN position - all the way to the right.

The Stat-t Time Knob does lot show the correct time of lay or the knob is not all the Nay out.

The Stop Time Knob is not set shead to the time you want the Self-Cleaning cycle to stop.

SOLUTION

Plug the power cord into a live circuit with proper voltage. (See Installation Instructions.)

Replace household fuse or reset circuit breaker. In case of prolonged power failure, manually light burners. (See page 8.)

Clean with a straight pin. (See pages 24 and 26.)

Clean with a straight pin. (See pages 24 and 26.) If this fails, call an autho- rized Roper set-vice technician for service.

Contact an authorized Roper service technician to check air/gas mixture.

Let dry.

Push control knob(s) in before turning to a setting.

Set both the Oven Selector and Oven Temperature Control to CLEAN.

Reset clock to show the correct time 3f day. (See page 11.)

Move Lock Lever all the way to the right.

Seset the Start Time Knob to show :he correct time of day. Pull knob out alI the way.

See Step 3 in “Setting the controls” In page 21 for proper setting instruc- ions.

continued on next page

29