5. Set the voltmeter to read between 8 and
18 volts DC.
6. Touch the test leads to the J1 connector at terminals 1 (red) and 2 (orange). The DC voltmeter should indicate between 8 and 18 volts DC*. If not, replace the DSI con- trol.
1 (red) 2 (orange)
J1 Connector
Broil Function
1.Set the voltmeter to read 120 VAC.
2.Program the range for the Broil operation.
J1 Connector
*When power is applied to the range, a safety delay of 40 seconds takes place before the direct spark ignition control becomes operational. The opera- tion will last for a period of 4 seconds, and the direct spark ignition will again turn off (see the “Timing Chart” for the oven burners on page 10).
3.If the top burners spark, proceed to step 4. Touch the test leads to the J1 connector at terminals 4 (white) and 10 (black). The AC voltmeter should indicate 120 VAC. If not, check for the proper voltage at the power supply outlet, and check the main wiring harness.
4 (white) | 10 (black) | ||
|
| ||
|
|
|
|
|
|
|
|
J1 Connector
- 14 -
