Whirlpool MH6700XW, MH6701XW manual Changing the Pre-programmed Setting, Auto Set Temp

Changing the Pre-programmed Setting

You can change the pre-programmed cooking time and Cook Power in AUTO SETto the time and powe you most often use. To change the AUTO SETsetting, follow these steps.

1.Touch AUTO SETtwice.

2.Touch the Number Pads for the new desired cooking time. If high Cook Power is desired, skip to Step 5.

3.Touch COOK POWER.

4.Touch the Number Pad for the desired Cook Power.

5.Touch AUTO SET.Touch CANCEL. The oven will remember that time and Cook Power for future use. NOTE: If electric power ever goes off, the oven will go back to the

pre-programmed 2 minutes, 30 seconds at HIGH Cook Power setting.

Auto Set TEMP

Auto Set TEMP provides ten preset probe temperatures (see “Cooking with the Tempera- ture Probe” on page 19). One hundred ten (110)to one hundred ninety (190) degrees at

70% Cook Power can be set by touching TEMP and the corresponding Number Pad l-9. This provides a short-cut method for setting commonly used probe temperatures. The Auto Set Chart included with your microwave oven and the Auto Set Guide on the inner door panel help you use TEMP to cook various food items without having to look up the temperature.

A preset temperature of 165°F at HIGH Cook Power is available (after inserting the probe) by touching just the TEMP Pad. This temperature may be changed to any temperature from 90°F to 200°F allowing you to store your favorite cooking temperature and Cook Power. See page 14 instructions.

‘:,

‘&,,

ai-~

;’ .‘_

DO THIS... THIS HAPPENS...

Y

1.Put food in the oven and close the door.

2.Touch TEMP.

(Option: Skip to Step 6 if you want to use the pre-

set temperature and Cook Power.)

3.Touch a Number Pad for

the new temperature you want from 110°F to 190°F.

4.Touch COOK POWER. (Option: Skip to Step 6 if you want to cook at 70% power.)

The Display will show what you touched in degrees Fahrenheit. This example shows140”F

The COOK POWER Indicator Light will come on and the Display

will show “P-701’

continued on next page