Number Pads | Fan and light Pads |
The six pads at the bottom of the control panel control the
Touch Fan Pad for the desired fan speed.
Once you’ve touched a Command Pad to tell the oven what you want it to do, you’ll touch Number Pads to tell it...
-a time.
-a Cook Power.
-a food temperature.
(NOTE: If the temperature gets too hot
around the microwave oven, the ex-
haust fan in the vent hood will
automatically turn on the LOW setting to protect the oven. It may stay on up to an hour to cool the oven. When this occurs, the Fan Pad will not turn the fan off.)
Touch Light Pad for the desired cooktop or countertop lighting.
Audible Signals
Audible signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 60 seconds after cooking is done to remind you that something has been left in the oven. A 3 second tone signals the end of the Minute Timer function.) If you don’t hear a tone, it is because of incorrectly entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programmlng tone and reminder tone:
*Open the door.
*Touch CANCEL twice, then touch START.
4 Programming and reminder tones will be cancelled.
To replace the tones:
7 Repeat the steps above.
To remove all tones, except the Mlnute Tlmer slgnal:
* Open the door.
0 Touch CANCEL twice, touch 0, then touch START.
d All audible tones (including Minute Timer signal) will be cancelled.
To replace the tones:
* Repeat the steps above.
NOTE: If your electrlclty goes off, the tones will be replaced when the electrlctty comes back on.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows “88:88:’ If the electric power ever goes off, the Display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the Clock, but the Display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
.
Hi3
1. Touch CLOCK Sm.
The Display will show a “0”and the colon will start to flash. The flrst Number Pad must be touched wlthln 5 seconds or the Display will go blank. If this happens, touch CLOCK SETagain and continue.
