USING YOUR RANGE
BAKING/ROASTING (CONT.)
2. Choose the bake setting. | PRESS | YOU SEE |
BAKE
BAKE
3.Set the temperature (optional).
Do this step if you want to set a temperature other than 350°F. Press s to raise the temperature or t to lower the temperature in 5°F amounts. Use these pads until the desired temperature shows on the small display.
PRESS | YOU SEE |
TEMP
BAKE
(example for bake at 375°F)
4.When roasting, put your food in the oven.
You do not have to preheat the oven when roasting, unless your recipe recommends it.
Roasting meats and poultry
•For even cooking, place the meat on a rack in a shallow pan. This keeps the meat out of the drippings and allows the heat to circulate better.
•Use a meat thermometer for the most accurate doneness. Insert it so the tip is in the center of the largest muscle or thickest portion of the meat or poultry. Make sure the thermometer is not touching bone, fat, or the bottom of the pan.
5.Press START/ENTER.
A preheat conditioning time counts down the approximate preheat time after the oven temperature has been set and START has been pressed. The oven control automatically sets preheating times based on the oven temperature you select:
•For 245°F and less, the preheating time is 2 minutes, 30 seconds.
•For
•For above 450°F, the preheating time is 6 minutes, 30 seconds.
As the preheat conditioning ends, the selected oven temperature replaces “PrE” on the display and the time of day reappears. You will hear a 1- second tone indicating the oven is ready to use.
The ACCUBAKE® system electronically regulates the preheat time and temperature to maintain a pre- cise temperature range for the best cooking results. The preheat and set temperatures may be different at the end of the countdown. This is normal.
PRESS | YOU SEE |
START | ON |
ENTER
HEAT BAKE
5 SEC
(example for set temperature of 350°F)
YOU SEE
ON
HEAT BAKE
NOTE: You can change the temperature setting any time after pressing START/ENTER. You do not have to press START/ENTER again. The preheat time will not change if you reset the temperature before the countdown time ends.
continued on next page
15