Move the Water Softener into Place
1.Move the water softener into installation position. Set it on a level surface. If needed, place the water softener on a section of plywood, a minimum of 3/4” thick. Then, shim under the plywood to level the water softener, see Figure 7.
IMPORTANT: Do not place shims directly under the salt storage tank. The weight of the tank, when full of water and salt, may cause the tank to fracture at the shim.
ShimPlywood
Figure 7 (if needed for leveling)
2.Visually check and remove any debris from the water softener valve inlet and outlet ports.
3.Remove and discard the yellow plug and make sure the turbine assembly spins freely in the “out” port of the valve.
4.If not already done, put a light coating of silicone grease or petroleum jelly on the bypass valve
5.Push the bypass valve into the softener valve as far as it will go. Snap the two large holding clips into place, from the top down as shown in Figure 8.
IMPORTANT: Be sure the clips snap firmly into place so the single valve bypass will not pull out.
clip channel
Figure 8
correct assembly
clip |
|
outside diameter of water | outside diameter of clip chan- |
softener valve inlet and outlet | nel on single valve bypass |
NOTE: Be sure all 3 tabs of the clip go through the matching holes on the water softener valve inlet or outlet, and fully into the channel on the single valve bypass.
13