Troubleshooting
Problem: The voice over the microphone is too low.
Please make sure that the boom microphone is correctly placed close to your mouth. The white marking has to be in the direction of your mouth (BT2200/3200). In addition, the microphone sensitivity can be adjusted as required (page 24).
Make sure this white marking is in the direction of your mouth.
Problem: The call cannot be accepted during music and intercom usage. Make sure that the automatic call acceptance is activated. If it is set to manual call acceptance, you will have to press the [T] button to accept the call.
FCC Information
FCC ID: U6CCAMOS-BTS200
FCC ID: U6CCAMOS-BTS300
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may caused undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
32 | 33 |
