Pairing to an Audio Device
Operating and disconnecting the audio device
1). You can adjust the volume of the audio device with the [+] &
2). You can start and stop the music with the Mute key.
3). If the audio device is out of range from the headset, the connection will be interrupted.
4). If the audio device and headset are out of range of each other but come within range within 30 minutes, they will connect again automatically. After 30 minutes have passed while out of range, you will have to switch your headset and the audio device off then on to connect them again. If this does not work, please pair both units again.
5). To disconnect both devices, switch off channel 1 of the headset and the audio device. If the headset has not been paired to any other device, they will connect automatically after switching on.
NOTE: | The volume adjustment and other functions | |
may differ with some GPS systems. | ||
|
22
Intercom Function
Headset Distance
The BT2200/2300 is intended for communications between the driver and passenger. You will need one headset for each person. The BT3200/330 is intended for communications between the driver of one motorcycle to the driver of another. You will need one headset for each person.
Vox Function
1). The headsets are equipped with VOX function. Channel 2 will be muted if there is no active communication between headsets. Thus, no noise will be transferred between headsets during this time and all connected audio devices will be active.
2). The VOX function mutes automatically after 30 seconds if the headset does not detect any communication signals, perhaps because the signals are too low. 5 seconds before the intercom mutes, the headset paired as Master will get a signal. The Slave headset will provide a sound when deactivation of the VOX occurs.
3). To keep the VOX on after the signal (sound), the Master [voice] has to speak louder. It may be necessary to adjust the sensitivity of the microphone (page 24) to ensure continuous communications. After the VOX has turned off, it can be activated again by speaking with a loud voice into the microphone.
23
