Whistler BT3300, BT3200, BT2300, BT2200 Basic Functions and Operation, Pairing to a Cell Phone

Basic Functions and Operation

Function	Key/Action/LED	Signal
Activate channel 1	Press the [-’] key for 4 seconds until the red LED flashes.	4 Tones
	Press the [+] key for 3 seconds until the green LED flashes. If the
Activate channel 2	headsets haven’t been paired before, the headset go into SLAVE	4 Tones
	mode and starts flashing rapidly.
Stand-by	1 Flash per second	-----------
Deactivate channel 1	Press the [-] key for 3 seconds until the red LED flashes longer then	4 Tones
	release.
Deactivate channel 2	Press the [+] key for 3 seconds until the green LED flashes longer	4 Tones
	then release.
Pairing	Press the [+] key from power off status until the green LED starts flashing	5 Tones
	rapidly.
Connected	3 flashes per second	4 Tones
Redialing	Briefly press/release the [T] key.	-----------
	Press [-] & [+] simultaneously from power off status for 6 seconds and release.
Microphone sensitivity	low = 4 flashes	-----------
	middle = 2 flashes
	high = 1 long flash
Accept call	Manual: Press [T] key when hearing the call signal.	4 Tones
Stop/Play music	Press mute key for 5 seconds	-----------
Start/Stop intercom	Press mute key momentarily	1 Tone
Low battery status	Interval sounds every 30 seconds	-----------
Reset	iPress [R] key when the headset is turned on;.All LEDs turn off.	-----------

Pairing to a Cell Phone

Normally, you can connect every Bluetooth cell phone to the headset. However, depending on the phone type, some functions cannot be operated through the headset. This includes the automatic music rendering after a call, redialing, or other functions. Therefore, if you have problems with your mobile phone, please consult the phone’s owner’s manual.

Automatic and manual call acceptance

1). The headsets offer you the possibility to choose between automatic and manual call acceptance. Factory settings will be “automatic” call acceptance.

2). To change to manual call acceptance, activate channel 1 and press the [T] key for 5 seconds. If you want to change it to automatic again, press the [T] key again for 5 seconds. You will also hear a sound signal in your headset.

3). If the automatic call acceptance in activated, you will hear the ringing of the phone in your headset which will be automatically activated after 2-3 rings. To hang up the phone, momentarily press the [T] key.

4). If the manual call acceptance is activated, you will have to accept the call by pressing the [T] key during the call. To hang up the phone, you have to momentarily press the [T] key again.

17