Storing and Recharging Headset
Recharging Headset - (continued)
2). Connect the headset to the charger as described. Please make sure that the charger plug is inserted correctly into the headset.
3). The red LED is illuminated during the charging process. When the headset is fully charged, the red LED turns off. Disconnect the charger unit from the headset after the charging process.
4). If the battery status is low, you will hear a warning signal in the headset.
Check Battery Status
Press both volume keys
Low Battery: The red LED will flash approximately 4 times (fast)
Medium Battery: The red LED will flash approximately 2 times (slower)
Full Battery: The red LED will flash one time (long flash).
10
Storing and Recharging Headset
Battery Charge / Usage Time
Model | Charge |
| Usage Time | |
|
| |||
Time | Speaking/music/intercom | |||
| ||||
|
| |||
|
|
|
| |
BT2200/2300 | ~ 3h | ~180h | ~14h | |
|
|
| ||
BT3200/3300 | ~90h | ~7h | ||
| ||||
|
|
|
|
The usage times may vary depending on the number of connected systems. The battery must be replaced by Whistler personnel.
11
